Find below the extracts from the letters Albert Levy wrote in the British Journal of Photography of 1900
- https://archive.org/details/britishjournalph1900unse/page/726/mode/2up?q=albert+levy
- Full pdf
- Full txt
(see page 726)
NON-SLIPPING TRIPODS.
By Ausert Levy
Maxine a speciality of architectural views, both exteriors and interiors, have often wanted some arrangement to prevent the tripod from slipping After trying several ways as given once in a while in Tar British JouRNaL or PHorocrapxy or elsewhere, I could never find the real thing to cover the — ground fully, and even now what I propose may not be the exact desideratum but it is certainly more simple than the one I bought some time ago, and — which contained a quantity of screws and hinges, which made it at first rather awkward to use, and then not rigid enough to be of any use except it was used within a couple or so of inches from the ground, and then the tripod could not spread enough to be of any extensive use. I have thought of an arrangement which was much plainer to handle and use, with no hinges or screws liable to get out of order. I take three brass wires, of suitable length, ard threaded at one end for six inches, more or less, according to wants. At the smooth end of the wire I make a loop, so as to be able to pass a brass screw through the three wires, and, with a nut,fasten them together in the centre of the tripod. To the threaded end of the wire I screw two nuts to each wire, and now, at any required — height of the tripod’s legs, I make a small hole to insert the wire when needed, taking out one nut and screwing it back again, so that the legis _ held firmly between the two nuts screwed tightly. This arrangement I~ find much easier to handle and carry, lighter than what I saw before, and cheaper, not being patented so far as I know. I have not seen any one ~ like it before.
