Find below the extracts from the letters Albert Levy wrote in the British Journal of Photography of 1901

(see page 732)

PREVENTING THE TRIPOD FROM SLIPPING.

By AlBert Levy (Asniéres).

 

 

| Last year I gave you the hint for a small contrivance which was intended to

prevent tripods from slipping on floors, and although it was I think, the best thing out at that time, I found it for general ise rather heavy, as it is always to be used outdoors and has to be carried by hand.

I therefore thought I could find something less heavy, and perhaps also less bulky, and here is an explanation of what I am using now with perfect satisfaction, the same being used by me for light as well as for heavy cameras with safety. I take three slips of wood abort 4 to 316 inch thick, 4 inch wide, and about 24 to 30 inches long. I lay these flat one on top of the other, and bore a hole through all three of them within half an inch from end and insert through holes a thumb-screw, allowing to screw tight. Then beginning at twelve inches from that I bore holes through all three boards at regular distances from 4 tolin. apart to suit requirements up to the end. Now to use this; I open the three’slips of wood and insert, after laying same flat on the ground, one leg of tripod in each hole, as chosen for purpose wanted, regular or irregular. Above is a figure which shows the contrivance when opened.

This, however, is liable to move irregularly, as the legs when focussing or arranging the camera, may spread to right or left. To remedy this I have added another slip of wood between the two first holes, as in A and B, fastened with thumb-screws also, and this gives perfect rigidity all over. Now, when not in use the whole, which is of light but strong wood, folds up in a small compass of $ inch thick on allreriima 30 inches long, and can be carried easily within the regular tripod